Exchange 2010 – Service ‚MSExchangeTransport‘ failed to reach status ‚Running‘

Posted on Monday, April 12th, 2010 at 9:26 pm in

Hy

While installing another Exchange 2010 Server in a TestVM i’ve received the following error during the setup:

Error:

The following error was generated when “$error.Clear(); if ($RoleStartTransportService) {start-SetupService –ServiceName MSExchangeTransport }” was run: “Service ‚MSExchangeTransport’ failed to reach status ‘Running’ on this server.”.

The resolution is as easy as strange ;)

Before running the setup I’ve removed IPV6 from the NIC – Binding.

So after I’ve enabled the IPv6 Binding on the NIC again Setup was running fine.

Tags:

6 Comments

Add your comment

  1. Mabrar Sulaiman - September 6, 2010 at 9:50 am

    HI

    this solution is working. Greate.

    best regards
    mabrar

  2. Segun - April 11, 2011 at 5:48 am

    Hi,

    This is a strange solution but it sure does work!

    Thanks..

  3. realtors in columbia missouri - April 29, 2011 at 8:20 am

    I solved the problem by installing IPv6 protocol. I originaly turned it off because Exchange wanted a static IP address and I could not set it on the IPv6 because it kept telling me it was invalid. If anyone has information on this please let me know.

  4. abdul - May 13, 2011 at 12:14 pm

    thak you vermuch

    its really good,its working fine

  5. NfgRocket - August 3, 2011 at 7:50 am

    hi, thanks for your Great solution and very valuable web site, I spend around 2 hours until i catch your solution for enabling IPV6 Protocol for solving the problem of
    MSExchangeTransport‘ failed to reach status ‚Running‘.

    thanks and best regards,

  6. Vince - December 29, 2011 at 2:34 pm

    This is awesome… Why wont MS make this a prerequisite BEFORE we try to install Exchange!

Leave a Reply

Leave A Comment

Security Code:

Top